| Wire Rope Products |
| Chain Products |
| Synthetic Products |
| Rope - Cordage |
| Rigging Hardware |
| Truck Rigging |
| Specialty Rigging |
|
• Forged carbon steel
• Hot dipped galvanized. Galvanizing is to AST A-153 specification. •Tapped with standard UNC class 2 threads after galvanizing
READ AND UNDERSTAND
THESE WARNINGS AND INSTRUCTIONS BEFORE USING LIFTING
EYES AND NUTS.
CAUTION: NEVER EXCEED THE WORKING LOAD LIMIT. NEVER INSERT THE POINT OF A HOOK IN AN EYEBOLT. ALWAYS USE A SHACKLE. IMPORTANT: Instructions For Use 1. Do not exceed working load limit (WLL) as shown in the table below. The standard WLL’s are established for a vertical pull. The WLL is significantly reduced when angular loading is involved as shown in the table below. 2. When using lifting slings having two or more legs, make sure the load on each leg is calculated based on the angular loading. The eye nut with the correct WLL under those conditions must be used. 3. Make sure the eye nuts are properly seated by screwing them down completely. 4. Make sure the threads in the hole are clean and undamaged. 5. Loads must always be applied parallel to the plane of the eye and never across the plane. 6. Always stand clear of the load and lift the load with a steady, even pull. Do not shock load.  |
EYE NUTS - Forged Galvanized
 Eye Nuts - Forged Galvanized Carbon Steel  20-S Pad Eyes, Carbon Steel • Uses: Widely used on farm machinery, trucks, steel hulled marine vessels and material handling equipment • Standard Material: Drop-forged C-1038 carbon steel • Standard Finish: Self-colored 
  |
